Quarter vent covers on, and the stainless top edge trim.  And some other stuff…

Dug out the trunk latch to put in, and found its one of the many items that just never got any attention since it was taken off.  So I had to take a time out, and go back to cleaning items again.  Covered in dirt and over spray, took me a little while to get it all off.  Here are the parts, pretty much all cleaned.

Had to use a file to get the paint off the edges before I could insert the lock cylinder, but after that, it went together pretty quickly.

Quarter vents and stainless also installed on the passenger side.

Managed to get started on the driver door hardware. Latch installed, along interior pull handle and lock tab.  Yes, I even made new foam pieces duplicating the original ones.